Turning On The Appliance; Change The Programme; At The End Of The Wash Cycle - Whirlpool ADG 175 Instruction Manual

Turning On the Appliance

Starting a cycle wash
1 Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one (s ee the section entitled
"
Loading the Dishwasher ).
2 Pour in the detergent (see the section entitled Salt, Detergent and Rinse Aid ).
3 Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the
socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.
4 Open the door, press the ON/OFF button, and the ON/OFF light will turn on.
Press the program button to a sired wash cycle. and close the door . After 3 seconds, the machine will work.
Change the Program...
Premise:
1. A cycle that is underway can only be modified if it has only been running
for a short time. Otherwise, the detergent may have already been released,
and the appliance may have already drained the wash water. If this is the case,
the detergent dispenser must be refilled (see the s ection entitled " Loading the
Detergent " ).
2. Press current prog. Button more than 3 seconds to cancel the program ,
then you can change the program to the desired cycle setting (see the section
entitled " Starting a wash cycle. . . " ).
3. Press one of others prog. Button more than 3 seconds to cancel the runing program ,
translase the program which you press.
4. Press the display button more than 3 seconds to re-edit display time .
Forgot to Add a Dish?
A forgotten dish can be added at any time before the detergent cup opens.
1
Open the door a little to stop the washing.
2
After the spray arms stop working,you can open the door
completely.

At the End of the Wash Cycle

When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
The buzzer of the dishwasher moos for 8 seconds, only in this case the programme has ended.
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
All manuals and user guides at all-guides.com
"
"
13
"
3
Load the forgotten dishes.
4
Close the door, the dishwasher will start running again
after 10 seconds.