Water Connection; Connection Of Drain Hoses - Whirlpool Dishwasher User Manual

Water Connection

Cold water connection
Connect the cold water supply hose to a threaded 3/4 (inch) connector and
make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of
time, let the water run to make sure that the water is clear. This precaution
is needed to avoid the risk of the water inlet to be blocked and damage the
appliance.
Hot water connection
The water supply to the appliance can also be connected to the household hot water line (such as, central
system, heating system),as long as it does not exceed a temperature of 60°C. In this case, the wash cycle
time will be shortened by about 15 minutes and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as described in the
section for the connection to the cold water line.
WARNING:
In order to avoid that there is more water staying in the inlet hose, please close the hydrant after
using.(Not applicable to appliances without aqua-stop.)

Connection of drain hoses

Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the sink, making
sure to avoid bending or crimping. Use the special plastic support that comes with the appliance. The free
end of the hose must be at a height between 40 and 100 cm and must not be immersed in water.
Close the drain hose hook to the counter
Drain hose hook
Front
Counter
Drain pipe
ATTENTION. Please hang up the drain
hose either way of A, B or C
23