Whirlpool Dishwasher User Manual page 24

Unsatisfactory drying result
Problem Possible causes
The dishes are not Improper loading
drying
Too little rinse-aid
Dishes are removed too
soon
Wrong program
has been selected
Use of cutlery with
a low-quality coating
Error codes
When some malfunctions come on, the appliance will display error codes to warn you:
Codes Meanings
E1 Longer inlet time.
E3 Longer heating time,
but not reaching required
temperature
E4 Overfilled.
E6 Failure of temperature
sensor
E7 Failure of temperature
sensor
WARNING:
• If overflow occurs, turn off the main water supply before calling a service.
• If there is water in the base pan because of an overfill or small leak, the water should be
removed before restarting the dishwasher.
What to do
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once the
dishes are barely warm to the touch. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
In short program the washing temperature is lower.
This also lowers cleaning performance. Choose a
program with a long washing time.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
Possible causes
Tap is not opened, or water intake is restricted,or
water pressure is too low.
Malfunction of temperature sensor or of heating
element.
Too much inlet water.
Open circuit or break of temperature sensor
Short circuit or break of temperature sensor
27