How To Load The Racks; Wash Cycle; Programme End - Whirlpool ADG 7561 Installation And Maintenance Instructions Manual

3. HOW TO USE THE APPLIANCE

HOW TO LOAD THE RACKS

UPPER RACK - depending on the model
Multifunction support A three possible positions for long utensils, cups and
glasses.
Crockery holder B in horizontal position: cups/long utensils, in raised
position for plates and stemware.
Adjustable glass holder C Depending on the position, for small or long-
stemmed glasses.
Long-handled utensils (kitchen knives) must be arranged with
the sharp end facing in towards the appliance.
Cutlery basket D It can be placed on the upper rack when the "Half
load/Multizone" function is selected.
Rack height adjustment E The upper rack height can be adjusted even when
loaded.
Lower position:
Upper position:
The two handles E must be on same level.
Washing without the upper rack
If the appliance is equipped with the adjustable retainers shown in the figure, the
upper rack can be removed in order to accommodate large plates, trays etc.
Open the two retainers F and slide the top rack out.
When the upper rack is in place the retainers must always be
closed.
LOWER RACK - depending on the model
Plate holder G Fixed or foldable (space-saving for
pots and pans).
Cutlery basket H or
Cutlery basket J The grid I supplied can be fitted
into the cutlery basket to keep
items separate.
Sharp utensils that might cause injury must be placed in the cutlery basket with the sharp end facing downwards.
Arrange crockery so that water does not collect in cavities, ensuring that the spray arms turn freely.
Only use dishwasher-proof crockery and dishes. Do not use the dishwasher for washing wooden items, aluminium, tin, silver
cutlery or decorated crockery (unglazed).

WASH CYCLE

The dishwasher door must be closed and the water tap open.
To load crockery, open the door with caution:
beware of hot steam.
Close the door again. The programme resumes the cycle from where it was interrupted.
The wash cycle can be interrupted at any time by pressing
RESET.

PROGRAMME END

Exercise caution when opening the door: beware of hot steam.
Only press the OFF button once the START indicator lamp has switched off. All the indicator lamps switch off. Unload the appliance, starting from the
lower rack in order to avoid any residual drips of water falling onto crockery below.
For even better drying results, leave the dishwasher door open a little before unloading in order to allow the steam to
dissipate, helping the dishes to dry. The underside of the kitchen worktop must be protected (see instructions in "Maintenance
and Installation").
pull out the two handles E and
gently lower the rack.
pull the two handles E up until
the rack clicks into place
(standard position).
Retainer
closed
Changing the programme in progress/Resetting
- Press the START button for about 2 seconds, until the START
indicator lamp switches off.
- (Water drains for up to 60 seconds).
- The appliance is now ready to be restarted.
Full integrated models
- Press the START/RESET button (for 2 seconds).
- Close the door.
- (Water drains for up to 60 seconds).
- The appliance is now ready to be restarted.
F
F
Retainer
open
5