Turning On The Appliance; Change The Programme; At The End Of The Wash Cycle; Forgot To Add Dish - Whirlpool ADP 750 Instruction Manual

Turning On the Appliance

Starting a cycle wash
1 Draw out the lower and up per b asket, load the dishes and push them back.
It is commended to lo ad the lower bask et first, then the upper one (s ee the sectio n entitled
"
Loading the Dishwasher ).
2 Pour in the detergent (see the section e ntitled Salt, Detergent and Rinse Aid ).
3 Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of th e
socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.
4 Close the door, press the ON/OFF button, a nd the ON/OFF light will turn on. Press the program
b utton to select a desired wash cycle, After 3 seconds, the machine will work.
Change the Program...
Premise:
1 A cycle that is underway can on ly be modified if it has on ly been running fo r a short
time. Otherwise, the d etergent may have already b een released, and the a ppliance may
have alread y drained the wash water. If this is the case, the detergen t dispenser must
be refilled (see the section entitled " Loading the Detergent " ).
2 Wh en you press the start/reset button mo re than 3 sec onds, you can cancel the running
programme and selec t other pro grammes (see the section entitled " Starting a wash cycle. . . " ).
3 Wh en you select Intensive/Normal/Eco.Programmes, you can select the 3in1 fu nction.
If you open the door
will continue
Forgot to Add a Dish?
A forgotten dish can be added at any time before the detergent cup opens.
1
Open the door a little to stop the washing.
2
After the spray arms stop working,you can open the door
completely.

At the End of the Wash Cycle

When the wo rking cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supp ly and open the door of the dishwasher.
Wait for a few minutes before unlo ading th e dishwasher to avoid ha ndlin g the dishes and utensils while they
are still hot and more susceptible to break age. The y will also dry better.
Switch Off the Dishwasher
The program has ended, only if there appears a 0 in the digital display (remaining program time).
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
WARNING!
"
during a wash cycle
working after 10 seconds.
It is dangerous to open the door when washing, because the hot water may scald you.
"
, the machine will pause. When you close the door , the machine
3
Load the forgotten dishes.
4
Close the door, the dishwasher will start running again
after 10 seconds.
13
"