How To Load The Racks; Wash Cycle; Programme End - Whirlpool ADG 699 Manual

3. HOW TO USE THE APPLIANCE

HOW TO LOAD THE RACKS

UPPER RACK - depending on model
Multipurpose support A Three possible positions for long for utensils, cups
and glasses.
Dish holder B In horizontal position for cups/long utensils, in raised
position for plates and stemware.
Adjustable glass holder C Depending on the position, for small glasses or
stemware.
Long-handled utensils (kitchen knives) must be arranged with
the sharp end facing in towards the appliance.
Cutlery basket D It can be placed on the upper rack when the "Half
load/Multizone" function is selected.
Rack vertical height E The top rack height can be adjusted even when
adjustment loaded.
Lower adjustment: pull the two handles E outwards
Upper adjustment: pull the two handles E up until
The two handles E must be on same level.
Washing without the upper rack
If the appliance is equipped with the adjustable retainers shown in the figure the
upper rack can be removed to wash large plates and trays, etc. Open the two
retainers F and remove the rack from the guides.
When the upper rack is in place the retainers must always be
closed.
LOWER RACK - depending on model
Plate holder G Partially folding for maximum rack
loading flexibility.
Cutlery basket H or
Cutlery basket J The grill element I supplied can be
inserted to keep cutlery separate.
Zone K Intensive wash with "Power Clean".
Sharp utensils that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. Arrange
crockery so that water does not collect in cavities, ensuring that the spray arms turn freely.
Only use dishwasher-proof crockery and dishes. Do not use the dishwasher for washing wooden items, aluminium, tin, silver
cutlery or decorated crockery (unglazed).

WASH CYCLE

The appliance door must be closed and the water tap open.
To add dishes, open the door with caution:
Beware of hot steam.
Close the door. The programme resumes from where it was interrupted.
The wash cycle can be interrupted at any time by pressing
RESET.

PROGRAMME END

Exercise caution when opening the door: beware of hot steam.
Only press the OFF button once the START indicator lamp has switched off. All the indicator lamps switch off. Unload the appliance, starting from the
lower rack in order to avoid any residual drips of water falling onto crockery below.
For even better drying results, leave the dishwasher door open a little before unloading in order to allow the steam to
dissipate, helping the dishes to dry. The underside of the kitchen worktop must be protected (see instructions in "Maintenance
and Installation").
and lower the rack.
the rack fits in place (standard
position).
Retainer
closed
Changing the programme in progress/Resetting
- Keep the START button pressed for 2 seconds until the
START indicator lamp switches off.
- (Water drains for up to 60 seconds).
- The appliance is now ready to be restarted.
Full integrated models
- Press the START/RESET button (for 2 seconds).
- Close the door.
- (Water drains for up to 60 seconds).
- The appliance is now ready to be restarted.
F
F
Retainer
open
5