Whirlpool Dishwasher Quick Reference Manual

Hide thumbs Also See for Dishwasher:

Advertisement

Quick reference guide
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
ECO PROGRAM
WASH TIME DISPLAY
INDICATOR
Indicates the cycle duration and the remaining time (h:min). With "Delayed start"
When lit, it indicates that
selected it indicates the time remaining until program start: "h24" if above
standard program is active.
10 hours delay time remain and "h:mm" if below 10 hours delay time remain.
If "Fx Ey" messages appears on the display, see page 8 - chapter "What to do if...".
MULTIZONE
INDICATOR
When lit, it indicates the
wash in the upper or lower
rack only.
KEYBOARD LOCK
INDICATOR
When lit, it indicates that
keyboard lock is active.
PROGRAM
MULTIZONE
SELECTION
Allows you to choose
the washing zones.
BUTTON
The appliance washes
Push "P" button
both racks by default
(repeatedly) until
(indicators are not lit).
selected
To wash only in
program number
specific rack, press
is shown on the
this button
display (P1...Px) -
repeatedly:
see "Table of
programs" - next
only upper rack
page.
After 3 seconds
indicator lit
the cycle
remaining time is
only lower rack
displayed.
indicator lit
Whirlpool is a registered trademark of Whirlpool USA
KEYBOARD
ANTIBACTERIAL
LOCK
RINSE
This option allows you
This function activates an
antibacterial rinse at the end of the
to lock the buttons on
the control panel.
wash cycle, guaranteeing a further
reduction of bacteria.
Children will not be
able to accidentally
Press the button to activate or
start the dishwasher
deactivate the function.
by pressing the
This function can be used with the
buttons on the control
programs indicated in the table of
programs.
panel when this
option is selected.
The dishwasher door must be
kept shut for the entire duration of
If you want to activate
this option hold down
the program in order to guarantee
the button for
reduction of bacteria.
3 seconds.
If the door is opened the indicator
Repeat the same
lamp starts flashing.
operation to unlock
the panel.
POWERCLEAN
Thanks to the additional power
jets this option provides a more
intensive and powerful wash in the
lower rack, in the specific area.
DELAY INDICATOR
When lit, it indicates that delay
is active.
TABLET
DELAYED START
SETTING
BUTTON
This setting allows
Push the button (repeatedly)
to optimize the
to delay the start of the
cycle
program. Adjustable from
performances
0:30 to 24 hours. With each
according the type
press of the button, the
of detergent used.
delay start increases by: 0:30
Push the Tablet
if selection below 4 hours,
button (the
1:00 if selection is below
indicator lights up)
12 hours, 4 hours if selection
if you are using the
is above 12 hours. If 24
combined
hours reached, and the
detergents in
button is pressed, the
tablet.
delayed start is deactivated -
If you are using
"OFF" message is shown.
powder or gel
Then press the START
detergent, the
button. The delay time can
Tablet indicator
be adjusted after Start key
®
on the control
press. The dishwasher will
panel has to be off.
start after the set time.
SALT INDICATOR
RINSE AID
INDICATOR
When lit (at the end of the
cycle), the salt reservoir needs
When lit (at the end of the
to be refilled.
cycle), the rinse aid dispenser
needs to be refilled.
WATER TAP CLOSED
- Alarm
Blinks when there is no inlet
water or water tap is closed.
CANCEL/OFF
BUTTON
Push this button to
switch off the control
panel.
If pressed for 3 seconds
when a program is
running it cancels this
program. If pressed
for 3 seconds when
the dishwasher is off,
it drains the water out.
If pressed during
program and delayed
start selection it
cancels the selection
and returns to
previous cycle and
option selection.
5019 300 02470
Chart
START/PAUSE/
RESUME
BUTTON
Push this button to
start the selected
program: the
indicator lights up
and goes off at the
end of the program.
Press Start button or
open the door
during washing cycle
to pause the cycle -
the Start Indicator
blinks.
To resume the cycle
push Start button
and close the door.
EN -1-

Advertisement

Table of Contents
loading

Summary of Contents for Whirlpool Dishwasher

  • Page 1 Thanks to the additional power jets this option provides a more intensive and powerful wash in the 5019 300 02470 lower rack, in the specific area. EN -1- Whirlpool is a registered trademark of Whirlpool USA...
  • Page 2 Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: “contact@whirlpool.com”. Power consumption in: Left-on mode: 1.08 W / Off-mode: 0.40 W.
  • Page 3: First Time Use

    Water hardness level is factory set for medium-hard water (level 4). Ask your water supply company what the water hardness is..enter this value on your dishwasher Salt required German French English Water hardness Insert value is shown Detergents degrees °dH...
  • Page 4: Daily Use

    Daily check Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator Visual The rinse aid dosage can be adjusted to the detergent indicator used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4).
  • Page 5: How To Load The Racks

    How to load the racks UPPER RACK - depending on the model A - Adjustable flaps (2 or 4): In horizontal position for B - Cutlery basket: Can be placed in the upper rack when cups / long utensils / steemed glasses. the “Half load/Multizone”...
  • Page 6 Arrange crockery so that water does not collect in cavities, ensuring that the spray arms turn freely. Only use dishwasher-proof crockery and dishes. Do not use the dishwasher for washing wooden items, aluminium, tin, silver cutlery or decorated crockery (unglazed). In the baskets, dishes (e.g. plates,...
  • Page 7: Maintenance And Care

    For hygienic reasons it is recommended to run a high-temperature cycle (e.g. Intensive 65) at least once per month. It will help to keep the appliance clean, fully functional and avoid odours. Wash cycle The dishwasher door must be closed and the water tap open. To pause the program (e.g. if you want to insert an item):...
  • Page 8 - Clean the filters and spray arms. early (dishes are dirty and wet) - Too little water in the dishwasher’s water system. - Concave items (e.g. bowls, cups) must be arranged facing downwards in the rack. - The drain hose must be fitted correctly (for high mounted appliances, leave min.
  • Page 9 - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. - Clean dishes left in dishwasher for a long time - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher after end of cycle (e.g. when using “Delayed is normal.
  • Page 10 - Dishes should be put together, to avoid touching each other. Do not put glassware together in baskets. Use suitable program for glass..glasses not sparkling - Glasses unsuitable for washing in dishwashers - Some kinds of glass cannot be washed in the dishwasher. (porcelain)..permanent deposits on glasses - Rainbow effect.
  • Page 11 - Be careful when the door is open: risk of tripping! EC Declaration of conformity - The open dishwasher door can only support the weight of the loaded rack when This appliance has been designed, constructed and distributed in compliance with the pulled out.

Table of Contents