Cloning Your Radio To Another Psr-410 Or Psr-310 Scanner - Grecom PSR-410 Owner's Manual

stby softkey. The softkey will change to STBY to indicate that SAME
Standby Mode is active, and the scanner will alert when a matching SAME
message is received.
Press the STBY softkey again to exit SAME Standby Mode, or press MAN,
SCAN or PROG.
When your local NWS office activates a SAME warning that matches a
FIPS code stored in your scanner, you will first hear a siren alarm and see
the LED flash to alert you to the incoming alarm. The LED flashes RED for
warnings, YELLOW for watches, and BLUE for tests and administrative
messages.
The scanner sounds the siren until the NWS transmission of the 1050 Hz
Warning Alert Tone (WAT) begins. Once the WAT begins, the scanner's
speaker will unmute, and you will hear the WAT play as an alert that the
voice portion of the SAME warning is about to begin. You will then hear the
voice portion of the SAME warning.
Your scanner will resume SAME Standby operation 90 seconds after the
SAME warning starts. You may reset standby mode by pressing the STBY
softkey twice at any time.
Cloning Your Radio to Another PSR-410 or PSR-
310 Scanner
Your PSR-410 features a high speed data interface that can be used to
transfer the data from your scanner to another PSR-410 or PSR-310 scanner
from GRE.
To clone your radio to another unit, use a standard stereo patch cord
terminated with 1/8" male stereo phone plugs on each end to connect your
radio (the SOURCE radio) to another radio (the TARGET radio). Ensure
that both radios are powered on. Press the PROG key, then the GLOB
softkey to enter the Global Settings menu. On the SOURCE radio, scroll to
the Clone Send: option, then press the SEL key when you are ready
to send data from your SOURCE radio to the TARGET radio. Both working
memory and global settings are transferred.
NOTE: The contents of working memory on the TARGET radio will be
overwritten immediately when SEL is pressed on the SOURCE radio.
77