Grecom PSR-410 Owner's Manual page 67

Dedicated TUNE mode will always check for the presence of encoded
squelch modulation each time it finds an active frequency. If a valid
encoded squelch code is found, it will be shown on the display, and stored
automatically when you press STOR to create a new CONV object.
Dedicated TUNE mode also displays information about trunking control
channels and trunked voice channels it finds while tuning through the RF
spectrum. The following information is displayed for the various trunking
modes:
Trunked Mode
M o t o r o l a 3 6 0 0
b a u d c o n t r o l
channel
E D A C S c o n t r o l
channel
LTR home repeater
M o t o r o l a a n a l o g
voice channel
You may wish to use the PSR-410's Tune LED feature to obtain a visual
indication of signal strength using the tri-color LED. To activate the Tune
LED, press PROG, then the GLOB softkey. Press the 6 key until Tune
Off appears in the display. Use the 34 keys to toggle Tune
LED:
LED on or off, then press the SAVE softkey to save your changes to the
radio's configuration memory.
qq% SID:ssss Stt
where qq=decoding quality of the control channel
data, SID=System ID, and S=Site Number
qq% S:ss h/H s/S a/A
where qq=decoding quality of the control channel
data, S=Site ID, h/H=not home site/is home site, s/
S=not SCAT site/is SCAT site, a/A=not Aux CC/is
Aux CC
HR:hh A-HH-GGG
where HR=the home repeater number of the tuned
frequency, A-HH-GGG=the Area, Home Repeater
and Group ID of the LTR talkgroup
VC: lsTGID-nnnnn
where lsTGID shows the decoded talkgroup ID data
from the lowspeed data stream
Please note that the analog lowspeed data protocol
does not provide error correction, and some false
" VC: lsTGID " readings should be expected.
Analysis Display
67