Attach The Supplied Antenna To The Radio - Grecom PSR-410 Owner's Manual

Attach the three self-adhesive rubber feet to the bottom of the mounting
bracket in the spaces provided. The rubber feet help prevent sliding on
smooth surfaces, and will help prevent scratching of your desk or tabletop.
Do not use the rubber feet if you plan to attach the mounting bracket to a
fixed surface with screws.
Attach the two self-adhesive rubber washers to the inside of the mounting
bracket sides, over the holes that are used when attaching the bracket to
the scanner's side holes. Be sure to align the holes in the washer carefully
with the holes in the mounting bracket. The rubber washers help protect the
scanner's case from scratches.
Slide the scanner carefully into the mounting bracket assembly, and use
the two provided knurled knobs to secure the scanner within the mounting
bracket.
Connect the supplied DC power supply to your wall outlet. Connect the
coaxial power plug to the radio.
WARNING
To prevent electric shock, do not use the AC adaptor's polarized plug with
an extension cord, receptacle, or other outlet unless you can fully insert the
blades to prevent blade exposure.
Caution
• You must use a supplied AC adaptor.
• The correct orientation for the enclosed power adaptor is in a vertical or
floor-mount position.
Note: Plug the adaptor into an easily accessible power outlet located near
the equipment.

Attach the supplied antenna to the radio

Your scanner's sensitivity to various frequencies depends on its location
and the antenna's length. For best reception, adjust the antenna's length as
follows:
21