Faqs; Care; In Case Of Fault - GRE PSR-200U Owner's Manual

FAQs (Frequently Asked Questions)
The scanner is not working at all. What's wrong?
• The AC or DC adaptor might not be connected. Be sure the adaptor's
barrel plug is fully inserted into the DC 9V jack. The center tip of the
adaptor's barrel plug must be set to positive.
The scanner does not receive any stations or reception is poor. What's
wrong?
• The scanner might need to be initialized. Turn the scanner off then on
again, or initialize the scanner (see "Initializing the Scanner").
The scanner is on but does not scan. What's wrong?
• The squelch might not be adjusted correctly. Turn SQUELCH clockwise.
There might only be one channel or no channels stored in the scanner.
Store frequencies into more than one channel.
While scanning, the scanner locks on frequencies that have an unclear
transmission. What's wrong?
• Some frequencies programmed into the scanner might be the same as
"birdie" frequencies. Avoid programming "Birdie Frequencies" or only
listen to them manually.

CARE

Keep the scanner dry; if it gets wet, wipe it dry immediately. Use and store
the scanner only in normal temperature environments. Handle the scanner
carefully; do not drop it. Keep the scanner away from dust and dirt, and wipe
it with a damp cloth occasionally to keep it looking new.

IN CASE OF FAULT

Where a fault arises, contact your supplier. However, before you do so check
that the fault was not caused by an operational error. Carefully reread the
relevant section in the instructions.
36
PSR200U-OM.indd 36 2010/02/22 16:24:44