Trap Managers; Security Configuration; Change Password - Alcatel OmniStack 8008 User Manual

Trap Managers

The following figure and table describe how to specify management stations that will
receive authentication failure messages or other trap messages from the switch. Up
to 5 trap managers may be entered.
Parameter
Trap Manager Capability
Trap Manager IP Address
Trap Manager Community
String
Add/Remove
Enable Authentication Traps

Security Configuration

Use the Security Configuration screen to restrict management access based on a
specified password. The Administrator has write access for parameters governing
the switch. You should therefore assign a password to the Administrator as soon as
possible, and store it in a safe place. (If for some reason your password is lost, or
you cannot gain access to the system's configuration program, contact Alcatel
Technical Support for assistance.)

Change Password

This password is for the system Administrator, with access privilege of Read/Write
for all screens. Passwords can consist of up to 11 alphanumeric characters and are
not case sensitive.
(User name: admin; default password: switch)
Description
Up to 5 trap managers may be used.
IP address of the trap manager.
A community authorized to receive trap messages.
Add/remove strings from the active list.
Issues a trap message to specified IP trap managers whenever
authentication of an SNMP request fails.
Default: enabled
Security Configuration
3-11