Connecting Ac Power Cord - Christie LX66 38-VIV305-01 User Manual

Installation

Connecting AC Power Cord

This projector uses nominal input voltages of 120 V or 200-240 V
AC. This projector automatically selects correct input voltage. It is
designed to work with single-phase power systems having a
grounded neutral conductor. To reduce risk of electrical shock, do
not plug into any other type of power system.
Consult your authorized dealer or service station if you are not sure
of type of the power being supplied.
Connect a projector with peripheral equipment before turning on it.
(Refer to p22 ~ 25 for connection.)
CAUTION
For safety, unplug AC power cord when the projector is not in
use. When this projector is connected to an outlet with AC
power cord and the Main On/Off switch is on, the projector is in
stand-by mode and consumes a little electric power.
NOTE ON THE POWER CORD
The AC Power Cord must meet the requirement of the country where you use the projector.
Confirm the AC plug type with the chart below. The proper AC Power Cord must be used.
If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.
Projector side
20
For the U.S.A. and Canada
To the POWER CORD
CONNECTOR on the
projector.
Main On/Off switch
AC Outlet side
For Continental Europe
Ground
To the AC Outlet.
(120 V AC)
AC power socket
Connect AC Power Cord (supplied) to
this socket. AC outlet must be near
this equipment and must be easily
accessible.
To the AC Outlet.
(200 - 240 V AC)