Appendix; Troubleshooting - Christie LX66 38-VIV305-01 User Manual

Appendix

Troubleshooting

Before calling your dealer or service center for assistance, check the items below once again.
– Make sure you have properly connected the projector to peripheral equipment as described on page 22~25.
– Make sure all equipment is connected to AC outlet and the power is turned on.
– When you operate the projector with a computer and it does not project an image, restart the computer.
See Information by pressing the INFO. button to check the current projector condition before trying the solutions
below.
Problem:
No power
Image is out of focus.
No image
Image is dark.
Image is Left/Right reversed.
Image is Top/Bottom reversed.
70
– Solutions
– Plug the power cord of the projector into the AC outlet.
– Make sure the Main On/Off switch is on.
– See if the LAMP indicator lights red.
– Wait 90 seconds after the projector is turned OFF when turning the
projector back on. The projector can be turned on after the READY indicator
☞
turns green. ( "Turning Off the Projector" on page 29)
– Check the WARNING TEMP. indicator. If the WARNING TEMP. indicator
lights red, the projector cannot be turned on.
☞
( "Warning Temp Indicator" on page 62)
– Check the projection lamp. (
– Unlock Key lock for the projector in the Setting Menu. (
– Check if the air filter is fully installed and the filter cover is completely
☞
closed. ( page 63)
– Check the wattage of two lamps are the same. (
– Adjust focus of the projector. (
– Check the projection lens to see if it needs cleaning. (
– Moving the projector from a cool to a warm place may result in moisture
condensation on the projection lens. In such cases, leave the projector
OFF and wait until condensation disappears.
– Check the connection between your computer or video equipment
☞
and the projector. ( page 22–25)
– See if the input signal is correctly output from your computer. Some
laptop computers may need to change the setting for monitor output when
connecting to a projector. See your computer's instruction manual for the
setting.
– It takes about 20 seconds to display an image after turning on the projector.
– See if the selected system is corresponding with your computer or video
☞
equipment. ( page 39–40)
– Select correct input source once again through menu operation.
☞
( page 37–38)
– Make sure the temperature is not out of the specified Operating
Temperature (5°C ~ 35°C).
– Check if the shutter is released. (
– Adjust Brightness and Contrast in the Image adjust menu. (
☞
– Check the Shutter level. (
– Check each lamp condition and the LAMP 1/2 REPLACE indicators.
☞
( page 64, 69)
– Check the Ceiling / Rear item. (
☞
– Check the Ceiling item. (
☞
page 64)
☞
☞
page 59, 64)
☞
page 30)
☞
☞
page 30)
page 55)
☞
"Screen Setting" on page 49.)
"Screen Setting" on page 49.)
page 56)
page 66)
☞
page 45)