Roland Sonar V-Studio 100 Getting Started page 13

6.
Wait until the lower right of the screen indicates "Found New Hardware" and the "Found New
Hardware Wizard" appears.
* It may take some time for the "Found New Hardware Wizard" to appear.
7.
If you are asked whether you want to connect to Windows Update, choose "No" and then click
[Next].
8.
Choose "Install the software automatically (Recommended)" and click [Next].
9.
If the "Hardware Installation" dialog box appears, click [Continue Anyway] to proceed with the
installation.
* If you cannot proceed with the installation, click [OK] to cancel the installation, and then refer to "Driver Signing
Options setting."
10.
If the "Completing the Found New Hardware Wizard" appears, Click [Finish].
11.
When the "Installation has been completed." message appears, installation has been completed.
Click [Close] to close the "Driver Setup" dialog box.
12.
If the "System Setting Change" dialog box appears, click [Yes] to restart Windows.
If the installation was not completed successfully, disconnect the USB cable from the SONAR V-STUDIO 100
hardware, and uninstall the driver by executing "Uninstall", found in the same folder as the driver setup. Then
install the driver once again, being careful to follow the instructions for the installation procedure.
Installation and Registration
13