Windows Xp Users - Roland Sonar V-Studio 100 Getting Started

Installation and Registration
11.
The lower right corner of the screen will indicates "Installing device driver software," and the
driver will be installed automatically.
* If any other message is displayed, note the contents and close the message.
12.
When the "Installation has been completed." message appears, installation has been completed.
Click [Close] to close the "Driver Setup" dialog box.
13.
If the "System Settings Change" dialog box appears, click [Yes] to restart Windows.
If the installation was not completed successfully, disconnect the USB cable from the SONAR V-STUDIO 100
hardware, and uninstall the driver by executing "Uninstall", found in the same folder as the driver setup. Then
install the driver once again, being careful to follow the instructions for the installation procedure.

Windows XP Users

1.
Disconnect all USB cables (except those for a USB keyboard and/or USB mouse, if used), then start
up Windows.
2.
Close all currently running software (applications).
Also close all windows that are open. If you are using software such as antivirus programs, be sure to close these
programs as well.
3.
Insert the included "SONAR V-STUDIO 100 Driver CD-ROM" into your computer's CD/DVD-ROM
drive.
4.
Select "Start-Run" and enter "d:\drivers\XP\setup.exe" to start the driver installer.
(where d:\ is your disc drive).
* If a "Install Program As Other User" dialog box appears, click [Cancel] to quit the installation and then perform the
installation as an administrative account.
5.
The message "VS-100 Driver will be installed on your computer." appears. Click [Next].
* If any other message appears, follow the directions of the message.
10