Subscribe to Our Youtube Channel
Related Manuals for Redring Active
Summary of Contents for Redring Active
- Page 1 REDRING ACTIVE ELECTRIC SHOWER Installation and User Guide IMPORTANT: This booklet should be left with the user after installation and demonstration...
- Page 2 THIS APPLIANCE CAN BE USED BY CHILDREN AGED FROM 8 YEARS AND ABOVE AND PERSONS WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE IF THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE IN A SAFE WAY AND UNDERSTAND THE HAZARDS INVOLVED.
-
Page 3: Fixing The Shower To The Wall
These can result from toilets being flushed or We recommend that the installation is done in taps being turned on and off. the following sequence. When this happens your showering a. Fixing the shower to the wall temperature will be held within a controlled b. - Page 4 10. Your shower is provided with 2 wall-fixing positions in the backplate and 2 alternatives (compatible with S range showers). The top-fixing hole is a ‘key-hole’ slot, and should be marked and drilled first. Tighten top screw with head protruding about 10mm from the wall and hook the backplate over the screw head.
- Page 5 Cable Cable Rating Fuse / MCB Sizes Length WARNING: 4.0mm² 21m Max. BEFORE CONNECTING THE PIPE WORK TO 6.0mm² Type B MCB 35m Max. 7.2 / 6.6kW THE SHOWER, ENSURE THAT THE PIPE 240 / 230V 6.0mm² 27m Max. WORK IS FULLY FLUSHED OUT. 10.0mm²...
- Page 6 WARNING: 9. Set the power select knob to cold (single blue bar) 9 o’clock position and turn DO NOT FIT A TAP ON THE temperature knob fully anti clockwise to SHOWER OUTLET. allow the unit to fill with water prior to any heat settings being selected.
- Page 7 Ensure the electricity and water are turned on to the unit. Your shower has 2 control knobs (fig.12). Knob ‘A’ controls the power selection. ‘High’ (3 red bars) ‘Economy’ - (2 red bars) ‘Cold’ (1 blue bar) Knob ‘B’ controls the temperature of the water. TO START THE SHOWER TO STOP THE SHOWER Turn Knob ‘A’...
- Page 8 WARNING: DO NOT SWITCH THE SHOWER ON IF YOU SUSPECT IT OF BEING FROZEN. WAIT UNTIL YOU ARE SURE IT HAS THAWED OUT. It is recommended that the shower unit and WARNING: accessories be cleaned using a soft cloth and DO NOT OPERATE THE SHOWER IF that the use of abrasive or solvent based cleaning fluid be avoided, especially on any...
-
Page 9: Professional Service
Spray Clean the shower handset. pattern poor Please contact us on our after sales Broken service department (See Section 5). parts Fitting instructions are provided with most spares SELF HELP PROFESSIONAL SERVICE If the shower is not working satisfactorily, make If the previous ‘Self Help’... - Page 10 6. As a further safeguard, a thermal cut-out switches the power off if the water temperature climbs above the set limit. This cut-out, which gives an audible click, may also operate due to residual heat when the shower is switched off. It will reset itself if water is run through the shower for 10 to 20 seconds.
- Page 11 Effect of Seasonal Incoming Water Temperature Changes The required water temperature is achieved by adjusting the rate of water flow. The diagram shows the principle involved in relating temperature rise to flow rate. The higher the water rate Please Note:- the lower the temperature The fitting of Spare Parts must be supervised and vice versa.
- Page 12 We DO NOT recommend these products be used in heavy or unsupervised commercial applications. f) For the service work to be undertaken free of charge, the work must only be undertaken by Redring Xpelair Group Limited, or our approved agents. g) Service under guarantee has no effect on the expiry date.
Need help?
Do you have a question about the Active and is the answer not in the manual?
Questions and answers