Advertisement
Ensure the electricity and water are turned on to
the unit.
Your shower has 2 control knobs (fig.12).
Knob 'A' controls the power selection.
'High'
'Economy' -
'Cold'
Knob 'B' controls the temperature of the water.
TO START THE SHOWER
Turn Knob 'A'
to your desired
Power setting
(normally 'High').
Water will start
to flow (fig.10).
It is recommended that you do not wholly enter
the water spray during this period, especially if
the shower has just been used.
If the water is not at your desired showering
temperature, turn Knob 'B' a small amount
until the desired temperature is achieved.
Turn anti-clockwise for cooler (fig.11a).
Turn clockwise for warmer (fig.11b).
11a
Allow about 20 seconds for the temperature
of the water to stabilise.
Final adjustment may be anywhere on the scale.
If after turning fully anti-clockwise, water is still
too hot, adjust Knob 'A' to 'Economy' setting
and re-adjust as previously detailed.
Water flow will be reduced on this setting.
-
(3 red bars)
(2 red bars)
-
(1 blue bar)
10
11b
12
TO STOP THE SHOWER
Turn 'Knob A'
to the 'Stop' position
(fig.13).
Water will cease
to flow.
Switch off the
electricity at the
ceiling switch or
local isolator.
Once a temperature setting to your liking has
been achieved, Knob 'B' will rarely need
adjusting. You must however take into account
required adjustments for variations of incoming
mains water temperature between summer and
winter (see 'Advice to users' on page.2).
The 'Economy' setting of Knob 'A' reduces the
power used by the shower giving a cooler
shower or the option of reduced water flow.
This option is mainly for summer usage and if
this is used then Knob 'B', must be re-adjusted.
The 'Cold' setting of Knob 'A' will supply water
without any heating.
During normal operation, if an overheated water
temperature is sensed then the heater will switch
off.
Water will continue to flow and cool down before
the heater switches back on again.
It will automatically reset itself when water has
been run through the shower for a few
moments. You may need to increase the water
flow by rotating the temperature knob
anti-clockwise to avoid this happening again.
7
13
Advertisement
