Related Manuals for Redring Active 320S
Summary of Contents for Redring Active 320S
- Page 1 REDRING ACTIVE 320S SMART TECHNOLOGY ELECTRIC SHOWER Installation and User Guide IMPORTANT: This booklet should be left with the user after installation and demonstration...
-
Page 2: Table Of Contents
What to do if things go wrong (2) Professional Service _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Redring After Sales Service _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6... -
Page 3: How To Use Your Active 320S Shower (Detailed)
9. Isolate the mains electrical and water supply before removing the front cover of the appliance. HOW TO USE YOUR ACTIVE 320S SHOWER (DETAILED) 1. Ensure the electricity and water are turned on to the unit. 2. Your shower has 3 power settings selected by turning outer knob “A”. -
Page 4: How Your Active 320S Shower Works
WARNING: CONSIDERATION SHOULD BE GIVEN TO SUPERVISING THE YOUNG, ELDERLY AND THE INFIRM WHILST THEY USE THIS SHOWER HOW YOUR ACTIVE 320S SHOWER WORKS 1. Water is heated instantaneously as it flows over the heating elements in the copper cylinder (diagram 2). -
Page 5: How To Maintain Your Active 320S Shower
This will be indicated by the neon light going out. HOW TO MAINTAIN YOUR ACTIVE 320S SHOWER It is recommended that the shower unit and hose etc. be cleaned using a soft cloth and that the use of abrasive or solvent cleaning fluid be avoided. -
Page 6: What To Do If Things Go Wrong (2) Professional Service
Check circuit through microswitches. If defective then replace. knob “A” is Power supply not reaching shower. turned. REDRING AFTER SALES SERVICE We offer a technical advisory service on the telephone to contractors and other customers with problems in the field. RING 08709 000430 (UK ONLY) -
Page 7: How To Install Your Active 320S Shower
Model Number: 53-67_ _ _ _ _ _ _ _ _ _ _ _ _ _ Serial Number: _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ HOW TO INSTALL YOUR ACTIVE 320S SHOWER WARNING: ALL WIRING AND INSTALLATION MUST BE SUPERVISED BY A SUITABLY QUALIFIED PERSON. - Page 8 6. Decide the position of entry of the cold water pipe into the unit. If top, cut away the backplate. If rear, please read the section on plumbing. If bottom, remove the front cover (complete with knobs) and cut away the detachable corner section as shown.
-
Page 9: Electrical
7. The shower is designed to have an open outlet and should only be used with ”Redring” recommended fittings. Do not connect the handset until after the shower front cover and corner section are fitted. WARNING: DO NOT FIT A TAP ON THE SHOWER OUTLET. - Page 10 5. Re-Fit the front cover (see diagram 9) a. Ensure outer knob “A” is aligned fully anti-clockwise to the “ (stop)“ position. b. Ensure inner knob “B” is aligned to the “ (high)” position. c. In the main body of the shower, turn the “Drive Spider” fully anti-clockwise until it stops. d.
-
Page 11: Additional Accessories And Spare Parts
Cat No. 93795809 Thermal Cut-Out 50/88°C Cat No. 93597871 Additional accessories and spare parts can be Handset Cat No. 93597860 supplied against any Credit or Debit cards Height Adjuster Cat No. 93597861 from Redring Sales Hotline 08709 000420 GUARANTEE AND CONTACT DETAILS... -
Page 12: How To Use Your Active 320S Shower (Summary)
TEL: +44 (0) 1733 456789 FAX: +44 (0) 1733 310606 Website: www.redring.co.uk HOW TO USE YOUR ACTIVE 320S SHOWER (SUMMARY) 1. Ensure the electricity and water are turned on to the unit. 2. Turn outer knob “A” clockwise to the “Power Select”... - Page 13 The position of inner knob “B” will be approximately the same each time the shower is used, varying only with incoming water temperature or pressure changes (e.g. you will only need to change from summer to winter). During normal operation, if an overheated water temperature is sensed then the heater will switch off and the neon indicator will go out.