Advertisement
WARNING:
DO NOT FIT A TAP ON THE
SHOWER OUTLET.
WARNING:
TAKE CARE TO AVOID
RESTRICTING THE OUTLET OF THE
PRESSURE RELIEF DEVICE.
6. Refit the detachable corner section onto the
backplate with the 4 x fixing screws (fig.2).
Ensure
7.
power select Knob is aligned to the
'stop' position, whilst the 'D-Shaft' in the
product is aligned as shown (fig.7).
7
Ensure
temperature Knob is aligned at 6
o'clock, whilst the 'spindle' in the product is
fully
rotated
clockwise as shown (fig.8).
8
Refit the front cover, and secure by replacing
the top and bottom fastening screws.
Ensure
that power select knob has been
correctly aligned by ensuring that all 3 power
settings can be selected.
Ensure
that temperature knob has been
correctly aligned by turning from minimum to
maximum flow (approximately 1 full turn)
mid position should be at 12 o'clock.
8. If you have not yet done so, assemble the
accessories (fig.9).
9. Set the power select knob to cold (single
blue bar) 9 o'clock position and turn
temperature knob fully anti clockwise to
allow the unit to fill with water prior to any
heat settings being selected.
10. Place seal washer into the shower hose nut
then tighten to the shower outlet pipe, and
operate the shower first without the handset
to flush out particles, fit the seal washer into
the other shower hose nut and then fit the
handset operate the shower as on page 7,
then please check:
That the water gets to a satisfactory
temperature and water flow can be
adjusted by the temperature knob.
That the power select knob operates in all
3 positions, giving a change in water
temperature.
Check again for leaks.
That the holes in the shower handset are
not blocked.
11. DEMONSTRATE OPERATION TO USERS,
AND LEAVE THIS BOOKLET WITH THEM
FOR FUTURE REFERENCE.
FIT
WASHER
BETWEEN
HOSE AND
HANDSET
HOSE
RETAINING
FEATURE
9
6
FORMED
RAIL END
LOCATES
INTO
LOWER
BRACKET
Advertisement
