Table of Contents
Advertisement
4.6 Send command via network to set TR-151
In
4.2.1 Adding and setting a
TR-151, you can connect TR-151 with TR Management center by
the USB cable to set its parameters. In
4.5 Send SMS to set TR-151
you can also set its
parameters by SMS via the Skype software in the TR Management center. You can also set the
parameters of TR-151 by network's command.
You could set the parameters of TR-151 via network only when TR-151 is under GPRS period
and disconnect mode, motion mode, park mode, Geo-fence mode and the report method must
be GPRS or GPRS + SMS.
4.6.1 Asking TR-151 to enter Geo-fence mode
Geo-fence is that setting a rectangular or circular area as permissible area or restricted area.
When TR-151 gets out the permissible area or goes in to the restricted area, TR-151 will send its
location to the preset mobile phone number via SMS or to TR Management center via network.
You can send command via network to make TR-151 enter Geo-fence mode. The commands
include choosing the rectangular or circular areas (Rectangle or Circle), getting in the restricted
areas or getting out the permissible areas to send alarm (In Geo-fence or Out Geo-fence) , time
intervals of alarm report (Report interval), Number of reports, and Report format.
TR-151 will start to get fixed of the location as soon as it enters Geo-fence mode. TR-151 will
keep fixing the location. Once TR-151 detect it enters restricted area or gets out the permissible
area, it will send its location to the preset mobile phone number via SMS or to TR Management
center via network.
Note: TR-151 will exit from geo-fence mode after it sends out the geo-fence alarm.
TR-151
page 93
Advertisement
Table of Contents
