Call Waiting - Yealink SIP-T20 User Manual

User Guide for the SIP-T20P/SIP-T20 IP Phone
2. Enter the number you want to transfer the call to.
3. Press
4. After the party answers the call, press
If you are using a handset, the transfer can be completed by hanging up the handset.
You can cancel the transfer before the call is connected by pressing
You can enable or disable call waiting on the phone. If call waiting is enabled, you can
receive another call when there is an active call on the phone. Otherwise, another
incoming call is automatically rejected by the phone with a busy message when there is
an active call on the phone. You can also enable or disable the phone to play a warning
tone when receiving another call.
To configure call waiting via phone user interface:
1. Press
2. Select Features->Call Waiting.
3. Press
4. Press
5. (Optional.)Enter the call waiting on code and off code respectively in the CW On
Code and CW Off Code field.
6. Press
Call waiting is configurable via web user interface at the path Features->General
Information.
You can create a conference with other two parties using the phone's local conference.
You can create a conference between an active call and a call on hold (on the same or
another line) by pressing the CONF key.
Note
Network conference is not available on all servers. For more information, contact your
system administrator.
70
or to dial out.
.

1. Call Waiting:

◄ *Enable ►
or to select Enable from the Call Waiting field.
or to select Enable from the Play Tone field.
to accept the change.
to complete the transfer.
.