Trane GECA -006 Installation Owner Diagnostics page 25

Installation of the GECA
Whether securing the GECA to a
central pumping system, or a dis-
tributed pumping system, Trane
recommends a few accessory con-
siderations to the system installa-
tion.
1
The field supplied line volt-
age disconnect with circuit
breaker should be installed
for branch circuit protection.
2 The units (2) high voltage
connection is located in the
right or left hand end pocket.
The field connection may be
made to the factory ordered
disconnect, or hard wired via
the factory mounted 2 x 4
handy box.
GECA-SVX01B-EN
Installation
Instructions
The (3) low voltage con-
3
nections may be made on
the right hand side of the
unit for units ordered with
the wall mounted thermo-
stat or sensor options. The
low voltage connection is
factory made if unit mount-
ed controls are specified.
Because of the units blow-
4
through design, no conden-
sate trapping is necessary.
However, it is necessary for
the condensate to run in a
downward motion to allow
gravity to produce a con-
stant outflow.
Hose kits are used to con-
5
nect the water supply and re-
turn lines to the water inlet
and outlets. Trane includes
various hose kit combina-
tions to better facilitate sys-
tem flow balancing. These
flexible hoses, reduce vibra-
tion between the unit and
the rigid piping system. For
more information on the
types of hose kits Trane rec-
ommends, review the HKTA-
IOM-1 manual.
The console design includes
6
a factory provided wall
sleeve to facilitate installa-
tion of the unit in it's estab-
lishment.
The grilles are made of a du-
7
rable plastic symetrical de-
sign. The design constitutes
the ability of a multi-direc-
tional supply-air from the
units top.
25