Trane GECA -006 Installation Owner Diagnostics page 23

16
Wall Mounted Control
The thermostat hook-up to the unit is made at the unit
mounted 24 V (18-pole) low voltage terminal strip. This
strip is mounted on the exterior of the control box on
the right side of the unit.
For units that contain left hand piping, a low voltage
crossover to the 18-pole terminal strip may be neces-
sary. For this configuration, run the low voltage wires
behind the chassis to the right side of the console unit
for termination to the terminal strip.
GECA-SVX01B-EN
Installation
Instructions
17
Thermostat Location
Location of the thermostat or zone sensor is an important
element of effective room control.
Areas where the thermostat/zone sensor should not be
mounted include: Behind doors or corners; Near hot or
cold air ducts; Near radiant heat (heat emitted from appli-
ances or sun); Near concealed pipes or chimneys; On out-
side walls or other non conditioned surfaces; In air-flows
from adjacent zones or other units.
18
Unit Mounted Controls
(Option)
For units with unit mounted controls, all low voltage con-
nections are factory made.
23