Table of Contents
Advertisement
Rear Terminal
①
① CONTROL PORT
When the projector is controlled by a computer,
connect to this jack with serial control cable.
②
COMPUTER IN 1 / COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal (pp.14,16).
③
MONITOR OUT
This terminal can be used to output the incoming
analog RGB signal and component signal from
COMPUTER IN 1/COMPONENT IN terminal or
COMPUTER IN 2/DVI-I) terminal to the other
monitor (pp.14,16).
④
COMPUTER IN / DVI-I
Connect computer output (Digital/Analog DVI-I type)
to this terminal (pp.14,16).
⑤
LAN Connection Terminal
Connect the LAN cable (refer to the owner's manual
"Network Set-up and Operation").
⑥ S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.16).
②
③
⑨
⑧
⑩
⑦
AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.14-16).
This terminal outputs sound from AUDIO IN
terminal (⑧ or ⑨).
⑧
COMPUTER 1 / COMPUTER AUDIO IN
Connect the audio output (stereo) from a
computer or video equipment connected to ②
or ④ to this jack. (pp14, 16)
⑨
AUDIO IN
Connect the audio output signal from video
equipment connected to ⑥ or ⑩ to this jack.
For a mono audio signal (a single audio jack),
connect it to the L (MONO) jack (p.15).
⑩
VIDEO IN
Connect the composite video output signal to
this jack (p.15).
Part Names and Functions
⑤
④
⑦
⑥
Advertisement
Table of Contents
