Table of Contents
Advertisement
Setting
On start
When this function is set to On, the projector will be
automatically turned on just by connecting the AC power
cord to a wall outlet.
Note:
Be sure to turn off the projector properly (see "Turning
Off the Projector" on page 20). If the projector is turned
off in the incorrect sequence, the On start function does
not work properly.
Standby mode
This function is available when operating the projector via
network.
Network .... Supply the power to the network function even
after turning off the projector. You can turn on/
off the projector via network, modify network
environment, and receive an e-mail about
projector status while the projector is powered
off.
Eco . ........... Select Eco when you do not use the projector
via network. The projector's network function
will stop when turning off the projector.
Refer to the owner's manual "Network Set-up and
Operation".
Note:
• Factory default is Network.
• When selecting Network, the cooling fans may be running
depending on the temperature inside the projector even if
the projector is turned off.
Advertisement
Table of Contents
