Table of Contents
Advertisement
Video Input
Sharpness
Press the Point
button to decrease the sharpness of the
◄
image; press the Point
of the image (from 0 to 15).
Gamma
Use the Point
buttons to adjust the gamma value to
◄►
obtain a better balance of contrast (from 0 to 15).
Noise reduction
Noise interference on the screen can be reduced. Select
one of the following options to get smoother images.
Off . ......... Disabled.
L1 .......... Lower reduction
L2 .......... Higher reduction
Progressive
An interlaced video signal can be displayed in progressive
mode. Select one of the following options.
Off . ......... Disabled.
L1 .......... For an active picture.
L2 .......... For a still picture.
Film . ....... For watching a film. With this function, the
projector reproduces pictures faithful to the
original film quality.
Reset
To reset the adjusted data, select Reset and press the
SELECT button. A confirmation box appears and then select
yes. All adjustments will return to their previous figures.
Store
To store the adjusted data, select Store and press the Point
or the SELECT button. Use the Point
►
select one from Image 1 to 4 and press the SELECT button.
A confirmation box appears and then select yes. Stored
data can be called up by selecting an Image (1–) in the
Image Mode Selection on page 40.
Note:
Noise reduction and Progressive cannot be selected
when 0p, p, 0p, 103i or 100i is selected
(p.39).
button to increase the sharpness
►
buttons to
▲▼
Store Menu
A confirmation box
appears and then
select yes.
Advertisement
Table of Contents
