Table of Contents
Advertisement
Appendix
The image is distorted or runs off.
PIN code dialog box appears
at start-up.
The Remote Control does
not work.
Indicator blinks or lights.
The exclamation mark appears
on the screen.
Top control does not work.
Unable to unlock the Logo PIN
code lock, Security key lock
or Security PIN code lock.
– Check PC adjust menu or Screen menu and adjust them.
See pages 31-32, 35-36.
– PIN code lock is being set. Enter a PIN code (the "1234" or numbers
you have set). See pages 19, 54-55.
– Check the batteries.
– Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector's code. See page 53.
– Unlock the Key lock function for the remote control function. See
page 54.
– Check the status of the projector with referring to "Indicators and
projector Condition". See page 70.
– Your operation is invalid. Operate correctly.
– The top control is not available if the top control is locked at Key lock
under Security of SETTING section. See page 54.
– Contact the dealer where you purchased the projector or the service
center.
Advertisement
Table of Contents
