Adding And Removing Presets; Setting Up Vhf - Fusion MS-IP700i Manual

ADDING AND REMOVING PRESETS

The 700 Series allows you to set up your favorite AM/FM stations, VHF or
SiriusXM channels as presets for easy recall.
Note: Up to 15 presets can be stored for each radio band.
Encoder Menu key
To add a new preset:
Do one of the following.
1. Tune the 700 Series to the required frequency or channel.
2. Press and hold down the Play / Pause key. The message: "Preset saved" is displayed
briefly.
or
1. Press the Menu key.
2. Turn and then press the Encoder to select Presets > Save current. The message:
"Preset saved" is displayed briefly.
To remove one or more presets:
1. Press the Menu key.
2. Turn and then press the Encoder to select Presets > Remove presets.
3. Do one of the following (there is no warning or confirmation prompt before
deletion):
• Select Remove all presets and press the Encoder to remove all
current presets.
• Select a preset and press the Encoder to remove the selected preset.
4. Press any key to exit

SETTING UP VHF

Note: A marine FM antenna is required for VHF reception, DO NOT connect to a VHF
splitter.
Minimizing background noise
Use the Squelch feature to reduce background noise on VHF input. Select a VHF chan-
nel, and then adjust the squelch control while there is nothing being transmitted on the
channel.
To set the squelch level:
1. Press the Menu key.
2. Turn and then press the Encoder to select Squelch.
3. Turn the Encoder to adjust the squelch level:
• Increase the squelch level until the background noise is muted.
• Reduce the squelch level if the audio transmission is not heard.
Play / Rewind
Pause
Fast Tuner
Forward
18