Initializing The System And Downloading Software; Booting A 7210 Sas-E In The Lab; Configuring The 7210 Sas-E; Figure 13: 7210 Sas-E Boot Process - Alcatel-Lucent 7210 Installation Manual

Initializing the System and Downloading Software

By default, 7210 platforms attempt the autoinit procedure unless interrupted by user and
Note:
forced to use Timos available in the flash.

Booting a 7210 SAS-E in the Lab

Port: 24
IP Address: 10.195.4.172/24
Gateway: 10.135.4.1
7210 SAS-E Installation Guide
The 7210 SAS-E ships with bootloader and TiMOS in flash. When the system is
powered up for the first time, the bootloader will attempt an auto-init procedure (see
the System Basics Guide for more information). The auto-init can, however, be
interrupted and the boot operation can be controlled manually.
There are several ways to boot the 7210 SAS-E from the network. User can choose to
boot the device using one of the following options:
• Using the image shipped along with the box to boot the device
• Using the network to load the image and boot the device
The following sections describe how to boot the device using either of the options
listed above.
SAS-E
Console Cable

Figure 13: 7210 SAS-E Boot Process

Configuring the 7210 SAS-E

FTP
Server
IP Address:
10.10.170.22/24
Page 49