Alcatel-Lucent 7210 Installation Manual page 63

7210 SAS-E Installation Guide
If you have used the out-of-band ethernet management port, then you do not
need to configure the IP interface. Instead jump to the step "Check IP
connectivity" below and continue from there
Change the mode of the connected port to 'access uplink'
A:SN12# configure port 1/1/24
A:SN12>config>port#
A:SN12>config>port# ethernet mode access uplink
A:SN12>config>port# no shutdown
A:SN12>config>port# exit
Configure an IES service.
A:SN12# configure service
A:SN12>config>service# info
----------------------------------------------
customer 1 create
description "Default customer"
exit
ies 2 customer 1 create
interface "in-band-mgmt" create
address 10.135.4.172/24
sap 1/1/24:0.* create
exit
exit
no shutdown
exit
----------------------------------------------
A:SN12>config>service#
Configure a route to the FTP server.
A:SN12#configure router
A:SN12>config>router#
Configuring the 7210 SAS-E
.
Page 63