Nuvo NV-WCPS Installation And User Manual page 34

Zone Settings: This selection contains several zone specific controls,
Fig. 25
Balance: This controls the level of audio going to the left and
right speakers. In some cases, when the listening area is not
absolutely centered between the speakers, it is useful to
adjust the center listening point left or right. This menu
option gives the ability to adjust the sound left or right up to
18 steps in either direction.
Bass: This adjusts the frequency level from 100Hz and below.
The default is flat, and the range is –18dB to +18dB.
Treble: This adjustment works within the same parameters as
the bass and adjusts the frequency level from 10kHz and up.
Loudness Compensation: Loudness can be simply turned on
or off by pressing the OK button.
Volume Settings: There are several default settings
available in this menu. Volume Reset is turned on or off by
pressing the OK button and controls whether the zone turns
on at its previous volume level, or to a preset level, Fig. 26.
If checked, the volume at zone on reverts to the level set in
the next menu item, Initial Volume. Choosing to set at the
current listening level, or selecting the default –60 dB level,
controls this level. Maximum Volume is an overall zone
volume limit and is set in the same manner as Initial Volume.
Page Volume controls the level at which a page is amplified
in each zone, and Party Volume sets the initial volume level
when the party or all-on function is initiated.
Display Settings: Display settings allows the Brightness to
be set at a level from 1-7. It also allows Auto Dim to be set
from 15 seconds up to 1 hour, and the choice of four levels of
dimness. It also allows the Time Display to be turned on or
off (note that this is a Grand Concerto only function).
31