Nuvo NV-WCPS Installation And User Manual page 20

The use of a Repeater should be limited to only those instances where it is necessary.
Each time a Repeater is added to the communication string the data throughput to the
Coordinator is reduced, and you should avoid more than two Repeaters in a string.
Therefore, best performance is achieved when the Coordinator is centrally located and
associated Repeaters communicate directly with the Coordinator.
Preferred method for Coordinator and Repeater location:
M3A 3:09 PM
1 of 9
Follow the Day
drift
Edge of Tomorr
1:28 3:48
POWER
MENU ZONE
OK
WCP Repeater
= 70% communication performance
Less preferred method for Coordinator and Repeater location:
POWER SETUP
Coordinator
= 49% communication performance
Once you have established communication between the Coordinator and the Repeater,
go to the Repeater's permanent location and plug it in. The LED should flash slowly
four up to 20 seconds and then turn off. This indicates that a message was successfully
sent to the Coordinator. If the LED continues flashing, move the Repeater to a location
closer to the Coordinator until the LED turns off indicating that the Repeater is able to
communicate with the Coordinator. For the best possible placement of the Repeater,
refer to the Link Status Indicator section on page 19.
SETUP POWER SETUP
Coordinator
POWER SETUP
Repeater
POWER SETUP
Repeater
POWER SETUP
Repeater
17
M3A 3:09 PM
1 of 9
Follow the Day
drift
Edge of Tomorr
1:28 3:48
MENU ZONE
OK
WCP
M3A 3:09 PM
1 of 9
Follow the Day
drift
Edge of Tomorr
1:28 3:48
MENU ZONE
OK
WCP