Nuvo NV-WCPS Installation And User Manual page 16

Zone Address (Fig. 7): When communication is established between the
Wireless Control Pad and the System's Coordinator, the Wireless Control Pad
will prompt you to set a "Zone Address". This establishes specific system
communication, but does not eliminate the ability to change zone control
using the "Zone" button. The zone addresses will appear as they have been
configured for the system. Any used zone addresses will be grayed out, and
not available for Wireless Control Pad setup. It is best to name zones in the
Configurator software for Wireless Control Pad use. Setting the Zone Address
is done by moving the highlight to the desired zone name or number and
pressing the OK button on the Wireless Control Pad. Note that you need to
reserve zone addresses that are not intended for use with an installed "wired"
Control Pad. The Grand Concerto System allows 20 total zone addresses and
the Essentia E6G allows 14 zone addresses. Any unused zone address can be
assigned to the Wireless Control Pad, with up to five total devices in one
installation.
Figure 7 – Zone Number
Zone Address
Master Bath
Entertainment Room
Kids Room 1
Kids Room 2
WCP 1
WCP 2
MENU ZONE
13