Out Of Box Setup Of The Wireless Control Pad - Nuvo NV-WCPS Installation And User Manual

III. Out of Box Setup of the Wireless Control Pad
When the Wireless Control Pad is first powered on, it is designed to guide the user
through a setup procedure outlined in this section.
Zone Button Configuration (Fig. 5): The Wireless Control Pad display will
ask if the device "Zone" button will be enabled or disabled. If enabled,
the user will have access to all of the System's active zones. These will
appear in the order they were configured in the NuVo Configurator
software, Fig. 5 (see the NuVo Prozone, NuVo University or the Grand
Concerto or Essentia E6G Installation Guide for complete zone setup
instructions). It is important to note if the Wireless Control Pad is to roam
from zone to zone, it must be associated with a zone address that is not
attached to a pair of speakers. If it is associated with a zone output that has
speakers attached it will always control the audio from those speakers. If
the system was set up without the use of the Configurator software, the
zone selection menu will appear as "Zone 1", "Zone 2", etc. Disabling the
Zone button will tie the Wireless Control Pad to a specific zone control.
Figure 5 – Zone Button Configuration
Zone Button
Enabled
Disabled
MENU ZONE
11