Using The Coordinator/Repeater As A Repeater - Nuvo NV-WCPS Installation And User Manual

IV. Using the Coordinator/Repeater as a Repeater (Fig. 10)
In some cases, good communication between the Wireless Control Pads and the
System's Coordinator may be challenged. Installing an additional
Coordinator/Repeater NV-WCPR component as an intermediate signal repeater often
can extend communication distance. This is easily done by setting the rotary switch on
the bottom of the additional Coordinator/Repeater to the "R" position. Then plug the
included USB power supply into the Coordinator and into an AC outlet. If desired, the
Repeater can be powered by NuVoNet.
To initially establish a connection to the coordinator, plug in the NV-WCPR in close
proximity to the System's Coordinator. Look for the SETUP LED to flash slowly and
steadily. It will flash while it is establishing communication with the Coordinator.
When it remains lit, press the SETUP button on the Coordinator and then on the
Repeater. The LED will turn off, indicating that Coordinator and Repeater are
communicating.
Figure 10 – Using the Coordinator/Repeater as a Repeater
POWER SETUP
The SETUP LED
flashes slowly while
it searches for the
Coordinator.
Set the Peripheral Device
address to "R".
16