Nuvo NV-WCPS Installation And User Manual page 31

Advanced Zone Control: Advanced Zone Control is designed for user access to
temporary zone settings. Each of the zone parameters set in Advanced
Zone Control automatically reset when an All Off command is issued from a
Control Pad, Fig. 20.
Party Mode: This setting is turned on and off with the OK button.
When selected all the configured zones in the system will turn on and
that Control Pad becomes the Host controller for the entire house.
This function is bypassed in an individual zone by initiating a new
function on that zone's Control Pad.
Do-Not-Disturb: This sets a temporary source lock on a chosen
source within that zone. This selection is also turned on and off by
pressing the OK button.
Sleep Mode: The Sleep Mode when set, allows music to play in that
Control Pad's zone for a specified amount of time, Fig. 21. Once the
time selection is made, the system will gradually ramp down in
volume and the zone will turn itself off at the end of the selected
time.
Lock Zone: This temporarily locks the zone on the current source
selection. It requires a four-digit security code that must be set in
the Settings Tab of the Configurator software. The security code is
entered on the Control Pad by using the Up and Down arrows to scroll
to the first number and pressing OK. The display will then highlight
the next number. Using the process described above sets the second,
third and fourth numbers. Once the fourth number is set, the zone
will remain locked until the security code is entered to unlock it, fig.
22.
Lock Zone & Off: This temporary lock works very much like Lock Zone,
but is used to turn the zone off and requires the security code to turn
the zone back on. Note that the security code is set in Configurator
software.
28