Preparation For Installation; Choose The Installation Place - Haier AB092XCERA Service Manual

4.7 Duct type AD***XLERA

2. Preparation for installation

Installation tools
Screw Driver (flat head, wabbler, triangle) 8
1
2 Steel Saw
3 60mm Drill
4 Inner Hexagon Spanner
5 Shifting Spanner
6 Spanner
7 Pipe Cutter
3. Accessories for installation
Self-contained accessories
No. A
Name of Non-adhesive
Parts
Tape

4. Choose the installation place

Install the indoor unit where the weight of the unit can be supported.
Install the indoor unit where the heat source and steam source are not close and the unit inlet
and outlet are not blocked.
Install the indoor unit where the drainage is easy and the outdoor unit can be easily connected.
Install the indoor unit where its cold air and hot air can be easily sent to all the corners of the
room.
Install the indoor unit where the power socket is near and there is sufficient space around the
indoor unit.
Install the indoor unit where there is no T.V set, radio set, and wireless appliance underneath,
and the sunlight lamp is over one meter away.
If the remote controller is installed on the wall, the indoor unit shall be ensured to receive the
signal while the sunlight lamp is on.
B C
Adhesive
Connecting
Heat insulation
tape
Hose
material
-64-
Pipe Expander
9 Knives
10 Clippers
11 Leakage Checker or Soap Liquid
12 Measuring Tape
13 Scraper or File
14 Refrigeration Oil
D E
Gypsum
powder
F
Drain hose