Connecting From Your Scanner As An Spp Bluetooth Device; Connectivity Matrix - Intermec SG20B User Manual

Chapter 5 — Connecting and Configuring the SG20B Scanner in Direct Connection

Connectivity Matrix

56
Connecting from your Scanner as an SPP Bluetooth
Device
This section describes how to connect your scanner from your
scanner.
To connect from the scanner
1 Once your scanner is paired, turn it on by pulling the trigger. Make
sure it is set as an SPP Bluetooth device.
2 Start EasySet version 5.6.5.1 or later. Make sure that SG20B is
selected as your product.
3 Select the Interface > Bluetooth > Connect/disconnect folder.
4 Double-click on the Compose BT address command. A
Bluetooth - Connect/disconnect - Compose BT address
window opens.
5 Compose your host Bluetooth Device Address (BDA) and click
OK. The Bluetooth association bar code is created.
6 Print and read the Bluetooth association bar code. The blue
Intermec Ready-to-Work starts blinking.
7 Open the incoming port that you noted at the end of the pairing
procedure, for example from a terminal emulation program.
When the scanner connects to your host PC, it emits a series of
beeps from low to high, and the blue Intermec Ready-to-Work
indicator turns solid blue.
8 To disconnect, close the incoming port.
When the scanner disconnects from your host PC, it emits a series
of beeps from high to low, and the blue Intermec Ready-to-Work
indicator turns off. The LED starts blinking.
A connectivity matrix listing all Bluetooth devices the SG20B scanner
can connect to is available. You can download it from Knowledge
Central on the Intermec web site.
To download the connectivity matrix
1 Go to http://intermec.custhelp.com.
2 In the search box type SG20B and click Search.
SG20B Cordless Scanner + Bluetooth Base Station User's Guide