Life Fitness 95L Service Manual page 116

Models 95L, 95LWEZ, and 95LE Summit Trainers
How To...
HOW TO... REPLACE THE RESISTOR BRACKET ASSEMBLY
Tools required: Phillips screwdriver, 3/8" nut driver, standard socket set
Estimated repair time: 20 minutes
1. Remove the users' right main
shroud (see "How To..." on page
86).
2. Document where each wire
terminates on the alternator.
3. Disconnect all wires attached to
the alternator.
4. Disconnect the connector end of
the cable from the power control
board at P2. A new cable is
included with the new resistor
bracket assembly and is already
connected to the resistors.
5. Remove the two Torx screws that
secure the resistor mounting
bracket to the frame.
6. Reverse steps 1 through 5 to
install the new resistors bracket
assembly.
114
Resistors
Torx Screws (2),
torque to
30-40 in-lbs
(3.4-4.5 Nm)
Resistor
Mounting
Bracket