Brother KE-430B Service Manual page 105

KE-434B, 435B, 436B
KE-434C, 435C, 436C, 484C
<KE-435B, 435C>
<KE-436B, 436C>
1) Insert horizontally from the
front so that the X-feed
lever cover is on top.
X-feed lever cover
2) Loosen the four
Insert this part of the belt cover into the
upper cover, install it with the two screws,
and then tighten the upper cover screw.
3446Q
KE-430B, 430C series
Provisionally
screw, and then fully tighten it
after installing the belt cover.
3444Q
1. Auxiliary plate supports
[4 pcs]
2. Screws [4 pcs]
3. Needle plate auxiliary
plate
4. Screws [4 pcs]
5. Auxiliary plate supports
[2 pcs]
6. Washers [4 pcs]
7. Screws [4 pcs]
8. Screws [4 pcs]
9. Shuttle race cover assy
10. Plain washers [2 pcs]
screws and make
11. Wave washers [2 pcs]
fine adjustments
12. Shoulder screws
to the height of
[2 pcs]
the needle plate
13. Face plate assy
auxiliary plate so
14. Screws [3 pcs]
that it is at the
15. Bolts [2 pcs]
same height as
16. Eye guard assy
the needle plate.
17. Screws [2 pcs]
18. Bed cover, R
3445Q
19. Screws [4 pcs]
20. Bed cover, LR
21. Screw
22. Bolts [2 pcs]
23. Bed cover, LF
24. Screws [4 pcs]
25. Frame side cover
26. Screws [4 pcs]
27. Top cover
28. Plain washers [3 pcs]
29. Screws [3 pcs]
30. Belt cover
31. Screws [2 pcs]
4. ASSEMBLY
tighten this
98