Brother KE-430B Service Manual page 100

4. ASSEMBLY
Refer to "4-20. Work clamp arm
mechanism (Applying grease)"
Carry out the adjustment in "5-24. Adjusting the
home position" before installing the feed plate.
After installing, carry out test feeding and check that the needle hole is inside the work clamp and the
feed plate frame. If the needle hole is not inside the frame, adjust the position of the work clamp arm
assembly and feed plate.
93
11. Feed bracket cover
12. Feed plate
13. Plain washers [2 pcs]
14. Bolts [2 pcs]
15. Work clamp arm assy
3434Q
16. Washers [2 pcs]
17. Bolts [2 pcs]
18. Cylinder support [Pneumatic spec. only]
19. Bolts [2 pcs: Pneumatic spec. only]
KE-430B, 430C series
Refer to "4-20. Work clamp arm
mechanism (Applying grease)"
Work clamp arm
installation position
(A) When using solenoid-type
work clamp S
Pneumatic-type
(B) When using solenoid-type
work clamp L
3433Q
assembly
3435Q