Service Calls For Hl-5270Dn/5280Dw; Errors List - Brother HL-5240 Service Manual

CHAPTER 4 TROUBLESHOOTING
2.2.2 Service calls for HL-5270N/5280DW
When each of the following messages appears alternately on the LCD, a user unrecoverable
error may have occurred.
Instruct the user to turn off the power switch, wait 5 seconds and then turn it on again. If the
error is not cleared and the same service call appears, identify the error from the table on the
next page and take the corrective action described for each indication to correct it.
ERROR ###
Error message
(Print Settings)
ERROR S01
ERROR S02
ERROR S03
ERROR S04
ERROR S05
ERROR S06
ERROR S07
ERROR S08
ERROR S09
ERROR S10
*
Error occurs.
Confirm the LCD
indication.
Turn OFF/ON
the power switch.
NO
Error occurs
again.
YES
See section 5.
'MALFUNCTIONS'.
Error descriptions
FATAL ERROR EX
ADRL ERROR EX
ADRS ERROR EX
BUS ERROR EX
(INSTRUCT)
BUS ERROR EX
(DATA L/S)
SYSCALL EX
BREAKPOINT EX
RESERVED
INSTRUCT EX
COPROCESSOR
UNUSAB EX
ARITHMETIC
OVERFLOW EX
* ### indicates the error codes.
Temporary error.
Use the printer with-
out corrective action.
Remedy
Turn off the printer. Wait a few seconds, then turn
it on again. If still remains, replace the main PCB.
Turn off the printer. Wait a few seconds, then turn
it on again. If still remains, replace the main PCB.
Turn off the printer. Wait a few seconds, then turn
it on again. If still remains, replace the main PCB.
Turn off the printer. Wait a few seconds, then turn
it on again. If still remains, replace the main PCB.
Turn off the printer. Wait a few seconds, then turn
it on again. If still remains, replace the main PCB.
Turn off the printer. Wait a few seconds, then turn
it on again. If still remains, replace the main PCB.
Turn off the printer. Wait a few seconds, then turn
it on again. If still remains, replace the main PCB.
Turn off the printer. Wait a few seconds, then turn
it on again. If still remains, replace the main PCB.
Turn off the printer. Wait a few seconds, then turn
it on again. If still remains, replace the main PCB.
Turn off the printer. Wait a few seconds, then turn
it on again. If still remains, replace the main PCB.
4-10 Confidential