Panasonic DBS576 User Manual page 68

6. Using Additional Features
5. To add another party repeat steps 1-4.
For 3-party Conference Call Only:
6.
To release a conference member, press PROG + 1 to release conference
member 1 or press PROG + 2 to release conference member 2, etc.
Note: The conference member numbers are shown on the display.
7. To drop out of the conference call, hang up.
To establish a two party private conversation from a 3-party
conference (Version 2.1 and higher)
While on a call, press the CONF + 1 (2) to have a private conversation
1.
with the CNF 1 (2) party as shown on the display.
To reestablish the conference, press CONF.
2.
To remove a busy tone (hang up) from an 8-party conference
(Version 2.1 and higher)
1. During an conference with more than 3 parties, press CONF + (n) (where n is the
number 1-8 for the conference parties) to individually select a conference party.
If you did not select the conference party that is giving busy tone, re-
2.
enter the conference by pressing CONF.
If you selected the conference party that is giving busy tone, hang up and
3.
then go off-hook again and press CONF to re-enter the conference call.
.
To establish an eight-party conference call
1. While on a call, press the HOLD key or the outside line key you are using.
2. Enter the 8-party Conference Set code (default = 788).
3. Press the HOLD key.
4. Access an outside line or dial the number of the extension you want to add to the
call.
5. If you accessed an outside line, dial the number of the party you want to add to
the call. Otherwise proceed to step 6.
6. Press the CONF key. (You are connected to the called party.)
68 DBS 576 (USA), issued January 1999 576-20-750