Assembling Flywheel, Hub, And Hub Cap - Keiser M3 User And Service Manual

Assembling Flywheel, Hub, and Hub Cap

Step 1: Before starting the assembly of the flywheel, hub, and hub cap, make sure that the shifter lever is in the
downward position.
NOTE: Not following this step may scratch the flywheel.
Step 2: Remove the plastic wrapping from around the axle, hub, and hub cap. Remove the hub cap. Obtain the 5 socket
head cap screws (M6x1 X 20 SS) and 5mm Allen wrench. Remove the flywheel from its foam envelope.
NOTE: Use the foam envelope to handle the flywheel during assembly.
Step 3: Carefully slide the flywheel between the two magnets and onto the hub at the same time. Make sure that the
flywheel is flush against the hub and align the screw holes.
Step 4: Holding the flywheel in position with one hand, install the hubcap and align the screw holes. Install the socket
head cap screws (M6x1 X 20 SS). Using the 5mm Allen wrench, tighten the screws in a star pattern until snug.
1
3
2
4
9