Shift Lever; Frame/Welds/Racks; Electrical Connections; Hydraulic Brake Systems - Arctic Cat 366 ATV 2008 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983

Shift Lever

CHECKING ADJUSTMENT
With the engine stopped and the brake lever lock
engaged, turn the ignition switch to the ON position;
then shift the transmission into each of the gear posi-
tions and note that the gear position indicated on the
LCD corresponds to the gear position selected by the
lever.
If the indicator does not correspond to the selected
gear, it will be necessary to test drive the ATV to deter-
mine if the gear shift position switch is faulty or the
shift lever needs adjustment.
If the ATV functions in the gear selected by the shift
lever, troubleshoot the gear shift position switch (see
Section 5).
If the ATV functions but the shift lever does not corre-
spond with the gear indicated on the LCD, adjust the
shift linkage. To adjust, proceed to ADJUSTING.
ADJUSTING
1. Remove the seat; then remove the left-side engine
cover.
2. With the ignition switch in the ON position, loosen
jam nut (A) (left-hand threads); then loosen jam
nut (C) and with the shift lever in the reverse posi-
tion, adjust the coupler (B) until the transmission
is in reverse and the "R" icon appears on the LCD.
www.mymowerparts.com
Back
KC165
Back to TOC
3. Tighten the jam nuts securely; then shift the trans-
mission to each position and verify correct adjust-
ment.
4. Install the left-side engine cover and seat making
sure the seat locks securely in place.

Frame/Welds/Racks

The frame, welds, and racks should be checked period-
ically for damage, bends, cracks, deterioration, broken
components, and missing components. If replacement
or repair constitutes removal, see Section 8.

Electrical Connections

The electrical connections should be checked periodi-
cally for proper function. In case of an electrical fail-
ure, check fuses, connections (for tightness, corrosion,
damage), and/or bulbs. If an electrical component
needs to be tested for proper function, see Section 5.
Hydraulic Brake
Systems
CHECKING/BLEEDING
The hydraulic brake systems have been filled and bled
at the factory. To check and/or bleed a hydraulic brake
system, use the following procedure.
1. With the master cylinder in a level position, check
the fluid level in the reservoir. On the hand brake
if the level in the reservoir is adequate, the sight
glass will appear dark. If the level is low, the sight
glass will appear clear. On the auxiliary brake the
level must be between the MIN and MAX lines on
the reservoir.
Back to Section TOC
KC194A
2
Next
2-15