Arctic Cat 366 ATV 2008 Service Manual page 58

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
5. Remove the V-belt.
6. Remove the fixed drive face.
7. Remove the nut holding the driven pulley assem-
bly; then remove the driven pulley assembly.
www.mymowerparts.com
Back
3-30
MD1034
MD1036
MD1118
MD1094
Back to TOC
8. Using an impact screwdriver, remove the three
Phillips-head cap screws holding the air intake
plate. Remove the air intake plate.
9. Remove the cap screws holding the clutch cover
onto the right-side crankcase half. Note the posi-
tions of the different-lengthed cap screws for
installing purposes.
10. Using a rubber mallet, loosen the clutch cover;
then pull it away from the right-side crankcase
half. Account for two alignment pins and gasket.
D. Gear Shift Position Switch
E. Centrifugal Clutch Assembly
F. Oil Pump Drive Gear
G. Oil Pump Driven Gear
NOTE: Steps 1-10 in the preceding sub-section
must precede this procedure.
Back to Section TOC
MD1068
MD1092
MD1115
Next