Removing; Adjusting Footrest Height; Model Phwh93; Model Ph904A And Phal4A - Invacare Pronto M94 Owner's Manual

REMOVING

1. Push the front rigging release lever INWARD and rotate the footrest OUT.
2. Lift up on front rigging and remove from the wheelchair.
3. Repeat STEPS 1-2 for opposite side of wheelchair.

ADJUSTING FOOTREST HEIGHT

MODEL PHWH93

NOTE: For this procedure, refer to FIGURE 9.2.
1. Remove any accessories from the footrest(s).
2. Remove the footrest from the
wheelchair. Refer to Installing/
Removing Front Riggings on page 50.
NOTE: Lay footrest on a flat surface to simplify
section.
3. Remove the hex bolt, coved washers
and locknut that secure the lower
footrest to the footrest support.
4. Reposition the lower footrest to the
desired height.
5. Reinstall hex bolt, coved washers and
locknut that secure lower footrest to
footrest support. Tighten securely.
6. Repeat STEPS 1-5 for the opposite side of the wheelchair footrest, if necessary.
7. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Front
Riggings on page 50.
8. Reinstall any accessories onto the footrest(s).

MODEL PH904A AND PHAL4A

NOTE: PH904A style front rigging shown.
PHAL4A front rigging adjust the same way.
NOTE: For this procedure, refer to FIGURE
9.3.
1. Loosen, but do not remove the lug bolt
and locknut that secure the lower
footrest to the footrest support.
2. Reposition the lower footrest to the
desired height.
Part No. 1122145
SECTION 9—FRONT RIGGINGS
Locknut
Coved
Washer
FIGURE 9.2 - ADJUSTING FOOTREST
HEIGHT - MODEL PHWH93
Footrest
Support
Lug Bolt
Lower
Footrest
FIGURE 9.3 - ADJUSTING FOOTREST
HEIGHT - MODEL PH904A AND
PHAL4A
51
Footrest
Support
Coved Washer
Hex Bolt
Lower
Footrest
Locknut
® ™
Pronto M94