Installing; Engaging/Disengaging Motor Release Lever - Invacare Pronto M94 Owner's Manual

INSTALLING

1. Perform one of the following:
A. TOP SHROUD - Position top shroud on to the base frame and gently press down
on top shroud to secure the four (4) hook and loop strips that secure the top shroud
to the base frame as shown in Detail "A" of FIGURE 10.1.
B. FRONT SHROUD - Position front shroud onto the two (2) base frame hooks. Turn
release knob ¼-turn to the locked position as shown in Detail "B" of FIGURE 10.1.
2. Install the seat assembly. Refer to Removing/Installing the Seat Assembly on page 41.
DETAIL "A" - TOP SHROUD
REAR OF
WHEELCHAIR
Base Frame
Hook and
Loop Strips
FIGURE 10.1 - REMOVING/INSTALLING THE SHROUDS
ENGAGING/DISENGAGING MOTOR RELEASE
LEVER
DO NOT engage or disengage the motor release lever until the On/Off switch on
the joystick is in the OFF position.
Ensure both motor release levers are fully engaged BEFORE driving the wheelchair
NOTE: The motor lock disengagement/engagement allows freewheeling OR joystick controlled
operation. Freewheeling allows an attendant to maneuver the wheelchair WITHOUT power.
Part No. 1122145
Base Frame
Top Shroud
Seat Supports
FRONT OF
WHEELCHAIR
WARNING
CAUTION
57
SECTION 10—SHROUD/WHEELS
DETAIL "B" - FRONT SHROUD
Hooks
Release
Knob
Front
Shroud
® ™
Pronto M94