Adjusting Seat Position On Seat Base - Van Seat Only - Invacare Pronto M94 Owner's Manual

SECTION 7—SEAT
4. Refer to FIGURE 7.7 to determine the correct mounting holes to achieve the desired
seat position.
5. Align the seat assembly mounting holes determined in STEP 4 with the seat frame
mounting holes determined in STEP 4.
6. Using the four (4) mounting screws and washers, secure the seat assembly to the seat
frame. Securely tighten.
7. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 41.
* DO NOT Use
Use these Mounting Holes
for 1-inch-back Seat Position
Use these Mounting Holes
for Standard Seat Position
* DO NOT Use
Use these Mounting Holes
for 1-inch-back Seat Position
Use these Mounting Holes
for Standard Seat Position
*NOTE: Only the 22-inch wide seats have these mounting holes. DO
NOT use these mounting holes.
FIGURE 7.7 - ADJUSTING SEAT POSITION ON SEAT FRAME
ADJUSTING SEAT POSITION ON SEAT BASE -
VAN SEAT ONLY
NOTE: For this procedure, refer to FIGURE
7.8.
1. Remove the seat. Refer to Removing/
Installing the Seat Assembly on
page 41.
2. Remove the seat assembly from the seat
frame. Refer to Adjusting Seat Position
on Seat Frame on page 43.
3. Remove the six (6) mounting screws
located under the seat that secure the
seat assembly in place.
® ™
Pronto M94
BOTTOM VIEW OF SEAT ASSEMBLY
FRONT OF SEAT
DO NOT Use
these mounting
holes.
REAR OF SEAT
44
* DO NOT Use
Use these Mounting Holes
for 1-inch-back Seat Position
Use these Mounting Holes
for Standard Seat Position
* DO NOT Use
Use these Mounting Holes
for 1-inch-back Seat Position
Use these Mounting Holes
for Standard Seat Position
Mounting
Holes
FIGURE 7.8 - ADJUSTING SEAT
POSITION ON SEAT BASE - VAN
SEAT ONLY
Mounting
Screws
Seat
Assembly
Part No. 1122145